Download the opensda driver for k64f

 · 2. Plug the FRDM-K64F to any USB port. Use the device manager to check if the OpenSDA drivers were installed correctly. Otherwise, download and install from the OpenSDA site.  · I am learning how to use the FRDM-K64F in the context of evaluating Orange France "IoT Soft box" starter kit. I am using a Macintosh, but tried also on a Windows PC and had the same problem. I keep the board reset button pressed and then plug it into the USB port release reset, the board shows up as "BOOTLOADER" USB drive.  · The Freescale FRDM-K64F and FRDM-K22F have a different OpenSDA (v2) firmware on it: unlike the earlier (v1), that firmware is open and not protected which is a great thing. However, it has the disadvantage if you use the wrong SWD/JTAG header on your board, the bootloader on the K20 OpenSDA microcontroller is gone: (This.

3. Keep RESET pressed while you connect the USB cable to the SDAUSB port J26 on the FRDM-K64F. 4. Release RESET. A drive called BOOTLOADER will show up on your PC. 5. Copy the file JLink_OpenSDA_bltadwin.ru onto the BOOTLOADER drive. After download and reprogramming is done the green LED next to the SDA connector starts to blink once a second. 6. output capability. There are two debug interfaces on the FRDM-K64F: onboard OpenSDAv2 circuit (J26) and K64 direct SWD connection (J9). Note To use an external debugger, such as J-Link, you may need to disconnect the OpenSDA SWD from the K To do this on the FRDM-K64F board, cut the shorting trace which connects the pins of jumper holes on. In the Update Driver Software dialog box, select Browse my computer for driver software. The driver is available in the PE OpenSDA driver package that you have installed as well as on the FRDM-KL25Z removable drive. Point to either location to locate the USB virtual serial driver. Click Next to complete the installation.

OpenSDA is a serial and debug adapter circuit that runs on a Kinetis K20 device built into many NXP development boards. It allows users to download and debug programs onto the target K64F chip using only a USB cable. Go to the bltadwin.ru page. Scroll down to the J-Link OpenSDA - Board-Specific Firmwares section. Click the plus sign to expand the list of ARM-based Freescale boards. Click the Download button next to FRDM-K64F and download the file 02_OpenSDA_bltadwin.ru to your computer. Go to bltadwin.ru and scroll to the end of the page with the OpenSDAv2 section and download the firmware. NOTE that you need the V (V2) for K64F, *not* the V! NOTE that you need the V (V2) for K64F, *not* the V!.